亚洲av无码一区二区三区性色|国产精品美女久久久|久久se精品一区精品二区|国产一区二区精品丝袜|99精品国产一区二区|中文字幕在线|国产精品久久久午夜夜伦鲁鲁|巜电车痴汉被爆乳女学生打扑克

The intermediate support bearing bracket of the transmission shaft will break down if it is used for a long time. The maintenance method is as follows:

After the intermediate bearing bracket of the transmission shaft is removed and decomposed, clean it, and then check whether there is no wear on the front and rear oil seals, whether the nozzle thread is damaged, whether the bracket is cracked or whether the rubber ring is corroded and aged. If cracks are found or the front and rear oil seals are worn or loose, timely welding or replacement should be carried out, and the rubber ring should be replaced due to corrosion aging.

What are the influencing factors of the transmission shaft balancing machine

Transmission shaft balancing machine adopts high performance inverter, high reliability, ultra-low noise, good linear speed regulation, automatic protection function. The factors affecting the drive shaft balancing machine are as follows:

1, the left and right support has high and low, so that the rotor left and right channel or journal plane and the support rub.

2. The supporting block is seriously worn or the roller run-out increases.

3, there is dirt at the support, no lubricating oil.

4, the installation of the balance machine foundation does not meet the requirements, the bottom combined with the surface is not solid, the anchor bolt is not fastened, or placed on the floor, causing resonance.

The output signal of the sensor is abnormal.

6. The fastening screw at the movable parts on the supporting frame is not fastened.

7, the belt does not meet the requirements, there are obvious joints.

8, balancing machine photoelectric head on positive and negative light paper, photoelectric head mirror blur, photoelectric head position deviation caused by Angle offset.